In this post I will try to unravel all the mysteries of cooking XD
First of all I have to remember that the fimo and cernit are two petroleum products, and then you can easily guess that cook in the same oven normally used for food is not the best thing to do.
During cooking these materials give off vapors exposure hazards to health which are going to deposit on the walls of your oven may be easily absorbed from foods that bake succesimante.
Although the creations Cover with waxed paper, but were careful to cook these substances are always issued .
For obvious security reasons, it is therefore necessary to have an oven
(with thermostat, so you can always check the temperature inside)
be used exclusively for cooking this type of material.
Another method is to put your creations for a few minutes in a pot of water boiling or baking creations in a water bath for about twenty minutes.
But what is the best way to cook?
BRING There is no better or worse, depending on the type of creations and what they find most comfortable ^ ^
method 1: baking oven (not in the oven where cook food)
pro: cooking is simple and effective for any type of creation
against: give off
2 ° method: cook in boiling water
pro: does not give off vapors
against: if the creations are the result of several parts put together, this type of cooking could ruin the creation being a little delicate cooking in boiling water stir too much as the creations, lead to cracking.
Not good for the creations with fimoliquid
the 3rd method: cooking in a water bath (put your creations on a plate and cover with a lid, then a pot with water Rempe , put it on the stove and appogiatevi the flat above)
pro: allows you to control the trend of the minute cooking
(just lift the lid and touch the creations)
against: is good only for creations Small size (up to 5cm)
warnings: the dish used for cooking should never be used more for food and the lid should be washed every time.
0 comments:
Post a Comment